Sanifloor + 1, for tiled floors

Sanifloor + 1, for tiled floors

Sanifloor+ allows a shower to be installed easily and economically without major work accessing sewer pipes. The pump sucks the water from the shower gully and discharges back to the existing sewer line. Installing a stylish walk-in shower is easy with a Sanifloor®+

  • Wireless communication between pump and plug
  • Installation without the need for major work
  • Large volume output 30l/min

To maintain radio signal integrity pump must be installed in same room with power cable end facing towards shower waste gully.


Sanifloor+ includes a suction pump and a plug, and makes it possible to install a walk-in shower without the need for major building work. The wireless detection system in the plug makes fitting particularly easy. The replaceable detection unit also simplifies maintenance. Designed specifically where floor drainage is required but where space...

See more

Sanifloor+ 1 datasheet

Dimensions l x w x h (mm)
295 x 191 x 164

*Packing list: Sanifloor+ pump, dedicated drain, check valve, connectors. 

Ref: EAN 3308815076232

Sanifloor + 1
Number of entries 1
Maximum flow rate 30 L/min at 1 m
Inlet pipework 16 mm
Discharge pipework 32 mm
Motor power 400W
Voltage 220-240 V
Frequency 50 Hz
Maximum absorbed current 1.7 A
Electrical class I
IP rating IP44
Max. temperature of the pumped liquid (5 min) 35 °C
Discharge length 30 m
Max. head (Q0) 3 m
Shower tray height 0 cm
Total height 68 mm
Materials used for the drain ABS / stainless steel
Outlet diameter of the drain 16 mm
Sanifloor + 1, for tiled floors

Sanifloor + 1, for tiled floors

  • Walk-in shower